Metal Disc and Crystal Necklace

A stunning necklace design that is full of colour.

Materials Needed

50 cm Large Link Silver Chain
5 x Metal Disc Beads
3 x 6mm Crystals
33 x 4mm Crystals
Jump rings
Lobster Clasp
Tip:  Make sure you lay the chain flat to ensure that you hang the pendants on the same side of the chain.
Step 1

Make up the first pendant by threading a 6mm crystal, a metal disc bead and then 3 4mm crystals onto a head pin and use round nose pliers to form a loop.  Attach this pendant onto the middle link of the chain.

Step 2

Thread six 4mm crystals on to head pin and use round pliers to form a loop (as seen in the picture.  Repeat this step 3 more times.

Step 3

Attach two of the crystal head pins onto the chain three links on from the centre pendant on each side.

Step 4

Thread a 4mm crystal, a metal disc bead and then two 4mm crystals onto a head pin and use round pliers to form a loop (as seen in the picture).  Repeat this step again.

Step 5

Attach two of the metal disc head pins onto the chain three links on from the crystal head pins.

Step 6

Attach two of the crystal head pins onto the chain three links on from the metal disc head pins.

Step 7

Thread a 6mm crystal and a metal disc bead onto a head pin and use round pliers to form a loop (as seen in the picture).  Repeat this step again.

Step 8

Attach the metal disc bead head pins onto the chain three links on from the crystal head pins.

Step 9

Attach a jump ring to each end of the length of chain and attach a lobster clasp to one end of the chain.

++